Parts

double cable front brakes?

Related Searches:
flat-ashura Joined: A long time ago... Posts: 636 Location: bowmanville, ontario	Date: 2006-07-14 06:24:29 Topic: double cable front brakes?
	how do, you set up front brakes with the 2 handles, and wires? "Arent you a little bit big for that bike" " arent you a little bit big for a side walk"
Dead Sailor Joined: A long time ago... Posts: 765 Location: Tampa	Date: 2006-07-14 13:55:10 Topic: Re: double cable front brakes?
	i wont even bother to tellu how to do it with a liner cable cuz its pretty sketcky and if u dont have a good cableu have to add alot of tension to the springs...and ull most likely have to take off your compression bolt..w/e do this instead its SO much easier. get a bottom gyro cable, try to get a "long"one. just run the single cable trough ur compression bolt(you get to keep it!), and then the two other ends just run them to the levers. and just pretty much set it up and adjust it exactly how you would if u had a linear cable going to the front break. paul oskia ran his brake like this a little ways back...im sure he still is
Kevyd Joined: A long time ago... Posts: 288 Location:	Date: 2006-07-14 16:18:39 Topic: Re: double cable front brakes?
Kevyd Joined: A long time ago... Posts: 288 Location:	Osicka ran his through a primo pervert. You can't simply install a gyro cable. You need to cut some of the cable housing off (where it goes into the lever) or else there isn't enough travel in the cable. I works ok at best.... TEAM WINNIPEG
Stubbleduck43 Joined: A long time ago... Posts: 459 Location:	Date: 2006-07-15 17:49:21 Topic: Re: double cable front brakes?
	Here's the easy way I've used. -Get you an Odyssey Slick cable -Cut the housing equal lengths on both sides of the levers to the brakes -Run the cable through one housing, through the brake and through the next housing to the other lever -Clamp down an Odyssey Knarp on the end of the cable with no barrel -Adjust as needed and go ride http://www.myspace.com/stubbleduck
Sponsored Results

New Thread